PostgreSQL version:

commit_delay

commit_delay adds a time delay, measured in microseconds, before a WAL flush is initiated. This can improve group commit throughput by allowing a larger number of transactions to commit via a single WAL flush, if system load is high enough that additional transactions become ready to commit within the given interval. However, it also increases latency by up to commit_delay microseconds for each WAL flush. Because the delay is just wasted if no other transactions become ready to commit, a delay is only performed if at least commit_siblings other transactions are active when a flush is about to be initiated. Also, no delays are performed if fsync is disabled. The default commit_delay is zero (no delay). Only superusers can change this setting.

In PostgreSQL releases prior to 9.3, commit_delay behaved differently and was much less effective: it affected only commits, rather than all WAL flushes, and waited for the entire configured delay even if the WAL flush was completed sooner. Beginning in PostgreSQL 9.3, the first process that becomes ready to flush waits for the configured interval, while subsequent processes wait only until the leader completes the flush operation.

Recommendations

A primitive form of group commit without asynchronicity. Performance testing of this is very mixed; only set to non-zero if you have time to test the specific performance impact on your workload. Reasonable values are 200 to 1000.

Comments

At postgresqlCO.NF (OnGres) we value your privacy and treat all data very seriously. We're fully GDPR compliant, and we continuously monitor and improve our data storage, retention and compliance mechanisms.

This web page does not, however, store any PII (Personally Identifiable Information). The only service that stores any data is Google Analytics, and we use it to gather analytics of the web page.

This website contains some data from the official documentation of the PostgreSQL.org project, and from Annotated.Conf, used with permission.

If you have any question or concern about our terms of service or privacy policy, please contact us at dataprotection _at_ ongres _dot_ com.

OK