PostgreSQL version:

max_connections

Determines the maximum number of concurrent connections to the database server. The default is typically 100 connections, but might be less if your kernel settings will not support it (as determined during initdb). This parameter can only be set at server start.

When running a standby server, you must set this parameter to the same or higher value than on the master server. Otherwise, queries will not be allowed in the standby server.

Recommendations

Should be set to the maximum number of connections which you expect to need at peak load. Note that each connection uses shared_buffer memory, as well as additional non-shared memory, so be careful not to run the system out of memory. In general, if you need more than 200 connections, you should probably be making more use of connection pooling.

At postgresqlCO.NF (OnGres) we value your privacy and treat all data very seriously. We're fully GDPR compliant, and we continuously monitor and improve our data storage, retention and compliance mechanisms.

This web page does not, however, store any PII (Personally Identifiable Information). The only service that stores any data is Google Analytics, and we use it to gather analytics of the web page.

This website contains some data from the official documentation of the PostgreSQL.org project, and from Annotated.Conf, used with permission.

If you have any question or concern about our terms of service or privacy policy, please contact us at dataprotection _at_ ongres _dot_ com.

OK